18mm "Hang Time" Streamer Duration Kit
This kit features balsa nose cone, quality spiral-wound body tube, shock cord made of DuPont KEVLAR® & thin wood fins. Each of the Streamer Duration kits include our "Hang Time " Tracing Paper Streamer Kits with enough materials to construct two streamers. The streamer size included with each kit is a good all - around size for the model size, but you may want to use a larger or smaller size depending on flying conditions. Be sure to check out other sizes of tracing paper streamers and the Silver Dura-Lar streamers for more options!
Specifications:
Length: 13.75"/34.9 cm
Diameter: .736"/18.7 mm
Approx. Weight (w/out recovery device): 0.51 oz/14.5 gm
Recommended Engines: 1/2A6 - 2; A8 - 3; A6 - 4; B6 - 6; C6 - 7
Skill Level: Beginner
Recovery Device: Streamer (6" X 60" Tracing Paper)
What you'll need to build this rocket:
Adhesives – a thin or medium viscosity cyanoacrylate ("CA") glue can be used for most steps and is recommended (other adhesives, such as wood glue, [i.e., Elmer's Carpenters Glue or Titebond] or epoxy can be used if you prefer and are familiar with their use, but the use of a CA glue will provide the lightest weight model); hobby knife with a sharp #11 blade; straight edge (preferably metal); sandpaper (medium - 220 or 280, fine - 320 or 400, & [optionally] extra fine - 500 or 600); ball point pen or pencil.
Recommended, but not required: sanding block; extender tip for cyanoacrylate glue.
Optional (see instructions): accelerator for cyanoacrylate glue; sanding sealer (or balsa fillercoat); thinner (appropriate type for the sanding sealer); clear dope; dope thinner; small paint brush; paint.
What else you'll need to fly this rocket:
Engines (see list above); Recovery Wadding; Electronic Launch System and Launch Pad
Specifications:
Length: 13.75"/34.9 cm
Diameter: .736"/18.7 mm
Approx. Weight (w/out recovery device): 0.51 oz/14.5 gm
Recommended Engines: 1/2A6 - 2; A8 - 3; A6 - 4; B6 - 6; C6 - 7
Skill Level: Beginner
Recovery Device: Streamer (6" X 60" Tracing Paper)
What you'll need to build this rocket:
Adhesives – a thin or medium viscosity cyanoacrylate ("CA") glue can be used for most steps and is recommended (other adhesives, such as wood glue, [i.e., Elmer's Carpenters Glue or Titebond] or epoxy can be used if you prefer and are familiar with their use, but the use of a CA glue will provide the lightest weight model); hobby knife with a sharp #11 blade; straight edge (preferably metal); sandpaper (medium - 220 or 280, fine - 320 or 400, & [optionally] extra fine - 500 or 600); ball point pen or pencil.
Recommended, but not required: sanding block; extender tip for cyanoacrylate glue.
Optional (see instructions): accelerator for cyanoacrylate glue; sanding sealer (or balsa fillercoat); thinner (appropriate type for the sanding sealer); clear dope; dope thinner; small paint brush; paint.
What else you'll need to fly this rocket:
Engines (see list above); Recovery Wadding; Electronic Launch System and Launch Pad