Message sent. Thank you for sharing this product with your friends!
Thermal Seeker 13 Streamer Duration Kit
This kit features a lightweight vac-form plastic cone, quality spiral-wound body tube, shock cord made of DuPont KEVLAR® & thin G10 fiberglass fins. Each of the Streamer Duration kits include our "Hang Time" Tracing Paper Streamer Kits with enough materials to construct two streamers. The streamer size included with each kit is a good all - around size for the model size, but you may want to use a larger or smaller size depending on flying conditions. Be sure to check out other sizes of tracing paper streamers and the Silver Dura-Lar streamers for more options!
Click here for an article that provides some tips on using our Tracing Paper streamers in competition models.
Length: 10.2"/25.9 cm
Diameter: .541"/13.74 mm
Approx. Weight (w/out recovery device): 0.25 oz/7 gm
Recommended Engines: 1/4A3 - 3T; 1/2A3 - 2T; 1/2A3 - 4T; A3 - 4T; A3 - 6T
Skill Level: Beginner/Intermediate
Recovery Device: Streamer (4" X 40" Tracing Paper)
What you'll need to build this rocket:
Adhesives – thin viscosity cyanoacrylate ("CA") glue; hobby knife with a sharp #11 blade; sandpaper (medium - 220 or 280, fine - 320 or 400, & [optionally] extra fine - 500 or 600); pencil.
Recommended, but not required: sanding block; extender tip for cyanoacrylate glue.
Optional: accelerator for cyanoacrylate glue.
What else you'll need to fly this rocket:
Engines (see list above); Recovery Wadding; Electronic Launch System and Launch Pad